Star Brite Star Tron Enzyme Fuel Treatment Gas 1 Gallon Treats 2048 Gallons

Description

Star Brite Star Tron Enzyme Fuel Treatment Gas 1 Gallon Treats 2048 Gallons
Helps prevent phase separation by dispersing water throughout fuel as submicron-sized droplets that are safely eliminated while the engine operates
Works in all engines and in all fuel
Removes and prevents gum, carbon and varnish
Cures and prevents most ethanol problems
One ounce will treat 16 gallons of gas
Star Tron Enzyme Fuel Treatment - Concentrated Marine Formula - Gasoline
Star Tron Enzyme Fuel Treatment is a multifunctional fuel additive which uses a unique enzyme technology. Helps all engines start easily and run smoothly, even when using ethanol-blended fuel or after sitting idle for months.
Cures and prevents ethanol fuel problems. Star Tron breaks down excess water and sludge to sub-micron size, allowing it to be safely burned away during normal engine operation which helps prevent phase separation.
Increases fuel economy by cleaning the entire fuel delivery system, removing performance robbing gum and varnish deposits while modifying how fuel burns. This results in more complete and uniform combustion, maximum performance, increased fuel efficiency, reduced emissions, and reliable operation.
Stabilize fuel for up to two years, preventing the formation of gums and other solids that clog carburetors and fuel injectors. Star Tron can help rejuvenate old and sub-spec fuel.
Recommended Uses
Star Tron can be used in all gas outboards, inboards, cars, trucks, motorcycles, ATVS, snowmobiles, small engines, outdoor power equipment including pre-mix fuel engines. Star Tron is safe for all engines, will not harm oxygen sensors, and overdosing is not harmful.
Directions
Initial Dosage: Add 1 fl. oz. (30 ml) for every 8 gallons (30 L) of gas.
Refill: Add 1 fl. oz. (30 ml) for every 16 gallons (60 L) of gas.
Overdosing is not harmful.
Reviews
1. I've been using this stuff for years without issue.
It especially works great for all engines that may sit for quite some time between uses, it keeps the gas from separating and varnishing.
I use it extensively in my 2-cycle engines to keep the small hoses soft for years--I typically get 2-3 years out of my trimmer fuel lines now as compared to 8-12mos without.
All my engines start right up now with no need to 'pull till I drop' anymore.
I use in my vehicles as a preventive measure though I haven't noticed any difference with/without--more fear of the horror stories from others in regards to the damage Ethanol causes...
2. I drive a 2015 GMC Sierra, 5.3 Liter gas engine with a 3.73 rear end. It is bit of a rare beast and is designed for heavy towing. Normally I get 14-15 MPG with untreated gasoline, 87 octane. With this additive, my mileage is 17+ MPG and I have better response and power from my truck. This additive is a notable improvement to untreated gasoline. Highly, highly recommended to those who own a vehicle with a V8 engine.
3. I've been using this for a while and it does work better than Stabil. I can notice it in my trucks somewhat, but the place where I really have seen a change is in my 2 cycle engines. Some of the equipment that was hard to start and ran rough now starts like new ans runs great. Thats the truth.